Hitachi SB10V2 Instruction Manual page 9

6. How to operate switch
The power switch is turned ON when the trigger is
pulled, and if the stopper is once depressed, the
power switch becomes locked, allowing
continuous operation.
The stopper can be released pulling the trigger.
(Fig. 6)
Trigger switch
7. Adjusting the belt speed: SB10V2
The Belt Sander is equipped with the electric
control circuit which enables stepless speed
control. To adjust the speed, turn the dial shown
in Fig. 7
When the dial is set to "1", the belt sander operates
at the minimum speed. When the dial is set to "5"
, the belt sander operates at the maximum speed.
Stopper
Fig. 6
Dial
Fig. 7
8. How to work on corner
Corners can be sanded and polished by using
machine as in Fig. 8.
English
Fig. 8
9