For The Installer - Scotsman FME2400R Service Manual

NME1850R & FME2400R

FOR THE INSTALLER

Location
Typical Storage Bin with Extension and Bin Top
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
around it to be accessible for service, usually a
minimum of 6 inches. Try to avoid hot, dirty and
crowded locations. Be sure that the location for the
machine is within the limitations described on page
3.
Storage Bin
Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Install the legs
into the threaded holes in the bottom of the bin.
Turn the leg levelers all the way in preparation for
leveling later. Return the bin to the upright position,
remove paper covering the bin gasket.
Install the bin top according to the directions with
the bin top.
Note: Do not push bin into position, but lift it there.
Pushing a bin, especially one with ice in it, can
cause damage to the legs and the leg mounts.
Ice Maker
The machine is heavy, so the use of a mechanical
lift is recommended for lifting the machine high
enough to install on top of the bin. After the unit is
placed on the bin, line it up so it is even with the
back side. Secure the machine to the bin with the
hardware provided with the machine.
Remove the front panel and remove any shipping
blocks.
Note: Be sure to allow a 6" minimum space
above the top of the machine for service.
January 1995
Page 5