Table of Contents
Advertisement
RF33
Installation
The machine should not be installed in a room that
o
falls below 50
F.
Level the cabinet by turning the leveling legs at the
base of the refrigerator.
Plug the refrigerator into the electrical power
supply.
Do not slide into place until the unit has been
started.
Freezing
Compartment
Location of Temperature Control
Operation:
To begin operation: Open the door, locate the
temperature control knob in the upper right portion
of the interior and rotate that knob clockwise until it
is about at the mid position.
The compressor and fan motor should both be
operating, unless the refrigerator is below 35
Check that air is flowing out the right side of the
grill.
The metal portion of the freezing compartment will
soon feel cold. That is the signal that the
refrigerator is functioning and the cabinet may now
be placed in its installed position.
Temperature
Control
Plastic Drip
Tray
November 1992
Page 6
The refrigerator will require some
time to cool the air and cabinet
interior. If desired, a thermometer
may be placed in the interior and
the temperature checked. The
RF33 should maintain
o
approximately 40
F. interior
temperature.
Note: As warm products are
placed in the refrigerator, the
refrigerator will likely operate for
some time to cool them. When the
refrigerator is empty, it will switch
on and off frequently because
there's only air inside, and the
temperature of the air changes
quickly.
The temperature of the
Refrigerator may be adjusted by
rotating the temperature control
knob: Turn the knob clockwise for
colder and counterclockwise for
warmer.
Placing ice trays in the freezing
compartment will reduce
refrigerating capacity.
Use: The refrigerator is
permanently lubricated, no oiling is
required. There are two things that
do require periodic maintenance:
The air cooled condenser and the
build up of frost on the freezing
compartment.
o
F.
Advertisement
Table of Contents
