Clover CDR0430 Instruction Manual page 60

Contents
6-5-2. Sensitivity Selection
From this option the user can select the Sensitivity level from 1 ~ 4.
The Red Square behind the menu area is a virtual simulation of how much
motion must be present for the DVR to sense through motion detecting.
To see the Red square, there must be movement at the camera and the
Sensitivity must not be set to OFF while in Motion Detection Setup.
The Sensitivity of motion is determined by the motion within a certain number
of cells. For example, if the Sensitivity is set to 1, then the Motion Detector will
trigger if the DVR senses motion in one cell.
The cell will be further explained in Chapter 6-5-4. Motion Area Setup.
- 59 -