Table of Contents
Advertisement
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing
downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product.
When the product is on the ground facing up or down, do not put pressure on it.
1
Insert the stand neck into the stand base in the
direction shown in the figure.
5
Hold the main body of the product with your hand
as shown by the figure. Push the assembled stand
into the main body in the direction of the arrow as
shown in the figure.
2
Check that the stand neck is firmly connected.
6
Connect the power supply and the signal cable as
shown in the figure.
Caution
Do not hold the product upside down only by the
stand.
3
Tightly fasten the connecting screw at the bottom
of the stand base.
Caution
Do not press down on the product. There is a risk of
damaging the product.
4
Place the protective Styrofoam (cushion) included
in the package on the floor and place the product
facing down on the Styrofoam, as shown in the
image. If Styrofoam is unavailable, use a thick
sitting mat.
18
Advertisement
Table of Contents
