Table of Contents
Advertisement
PRESS FILTER
RESET BUTTON
TIMER: DELAY STOP/START FEATURE:
THEN DO THIS:
PRESS UP/DOWN
BUTTONS
YOU WILL SEE HOW MUCH TIME IS
CHOSEN:
To delay stop(or start), press the Timer
button
when
the
power-o ), then the "timer o " indicator(or
"timer on" indicator) will illuminate. Then
adjust timer setting, tap or hold the UP arrow
( ) or the DOWN arrow ( ) to change delay
timer at 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The
setting will be confirmed automatically in 5
seconds, then the control will count down the
time(8h, 7.5h, 7h, etc.) left, and all other
settings will remain the same as they were
before the timer setting is confirmed, until
stop(or start).
OPERATING INSTRUCTIONS
DO THIS:
FIRST DO THIS:
PRESS TIMER
BUTTON
unit
is
power-on(or
Setting combination of "delay stop
delay start" or "delay start
is workable. Both "timer o " indicator and
"timer on" indicator will illuminate then. The
timer setting can be canceled by either
pressing and holding the timer button for 2
seconds, or pressing the power on/o button
at any time to turn o the unit directly.
HEATING FEATURE:
DO THIS:
PRESS MODE BUTTON
CHOOSE DRY
YOU WILL SEE:
Note: This feature can be used with any
combination of FAN Speeds (Low speed only
on 115V models), Timer, or Sleep Modes.
When in the "Heat" mode, the fan will run
continuously while heat is needed. The
temperature will automatically be maintained
anywhere
between
86 °F(30 °C).
When
temperature is satisfied, the fan will cycle o
and on to circulate and sample the room air.
Eco feature is invalid in heating mode.
17
turn off
delay stop"
turn on
62 °F(17 °C)
and
the
room
set
Advertisement
Table of Contents
