Advertisement
Configuring the Secondary Bridge Interface
1.
Navigate to the Network > Interfaces page from the
navigation panel.
2.
Click the Configure icon in the right column of the X0 (LAN)
interface.
3.
In the IP Assignment drop-down, select Layer 2 Bridged
Mode.
4.
In the Bridged to drop-down, select the X1 interface.
40
| Configuring L2 Bridge Mode
5.
Configure management options (HTTP, HTTPS, Ping,
SNMP, SSH, User logins, or HTTP redirects).
Note: Do not enable Never route traffic on this bridge-pair
unless your network topology requires that all packets
entering the L2 Bridge remain on the L2 Bridge
segments. You may optionally enable the Block all
non-IPv4 traffic setting to prevent the L2 bridge from
passing non-IPv4 traffic.
Advertisement
Chapters
