Brodit 527628 Installation Instructions

8 June, 2020, www.brodit.com, © 2020 Brodit AB
Product 527628
527628 Active holder for fixed installation Adjustable holder with Micro-USB connector. Fits for devices with
and without skin with the following dimensions: Width: 75-89 mm, Thickness: 6-10 mm. 2,1A charger. 12/24V.
With tilt swivel.
Keep your phone in a holder when on the road and you will always have it within easy sight and reach. The active
holder for fixed installation is to be connected inside the dashboard, this gives a discreet, neat installation without
cables hanging over the interior!
The adjustable holder fits for devices with and without skin with the following dimensions: Width: 75-89 mm,
Thickness: 6-10 mm. Adjustable holders come in various sizes. Measure your device and compare with the
holder specifications in order to make sure you have chosen the correct product (if you are using a skin: measure
the device with the skin in place).
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter
to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS
receiver of other own solutions (cannot be used for data communication or audio connection). The product is E-
approved. Connect the power cable with a 2A fuse. Professional installation recommended.
Before using the holder you need to confirm the charging cable is turned the right way (you can rotate it) and also
set the holder's width so it suits your device, then your phone is held firmly in place in an upright position for
maximum cellular reception. The holder has a neat and discreet design which blends well with the vehicle's
interior.
The holder is made of black ABS plastic. It is easy to put the device into the holder, and just as easy to take it
with you when leaving the vehicle. The holder is equipped with a tilt swivel so you can adjust the angle of your
device in order to avoid light reflection on the screen. You can tilt the holder 22° in each direction. Attach onto
ProClip Mounting Platform.
This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick
charge).
EAN: 7320285276284