Brodit 527940 Installation Instructions

3 March, 2017, www.brodit.com, © 2017 Brodit AB
Product 527940
527940 Active holder for fixed installation Adjustable holder. Micro USB. With tilt swivel and fly lead. Fits
devices with or without skin/case, with height 120-150 mm, max thickness 25 mm.
This holder is crash tested and approved for use with device without skin/case on Brodit's headrest mount.
Measure your device/skin/case and compare with specifications. Fits for devices with/without skin/case with
height 120-150 mm, max thickness 25 mm. For use with devices with Micro USB connector.
For connection inside the dashboard, no cables hanging over the interior. With fly lead, you manually connect the
charging cable to the device when needed (not automatic charging when placed in holder). With tilt swivel. Tilts
20°, swivels 360°. Padded cushions for protection against sliding/scratching. Mounting plate 42x50 mm with
predrilled AMPS-holes +2x3,5 mm centered holes. Connect the power cable with a 2A fuse. Professional
installation recommended. Made of high grade black ABS/Acetal plastic. Made in Sweden
Dimensions holder : 145 x 129 x 69 mm (W x H x D mm)
Weight: 272 g
Cable length: Total length: 400 cm (Connector to box: 145 cm, Box 8 cm, Box to open end: 243 cm.)
Crash tested:
This adjustable holder is crash tested according to standard for car seats (ECE R17). The crash test applies for a
tablet that weighs 490 g. The tests have been performed on one seat with invisible headrest pins (type Volvo etc.)
and one seat with visible headrest pins (type Ford etc.) in the forward and rearward directions. The adjustable
holder keeps the tablet in place during all executed tests.
Important information:
Tablets should not be installed onto a car's dashboard. They may block the view or key controls and the ProClip
is designed for installation of smaller devices (phones), not for large devices (tablets). Brodit will not give any
recommendations for such installations. An installation of a tablet onto a vehicle's dashboard is always done on
the customer's own responsibility. Brodit recommends to use tablets in a holder on the car's headrest, installed
onto a Brodit headrest mount.
EAN: 7320285279407
1 (2)