Wheel Gear 2, Main Cam And Opt Pinch Relay Gear - Sanyo SRT-4040 Basic Service Technical Information

3-15. WHEEL GEAR 2, MAIN CAM AND
OPT PINCH RELAY GEAR
(See Figs.3-15-1 and 3-15-2)
1) Refer to section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
2) Remove the clamp
.
3) Remove the washer
4) Remove the clamp
relay gear .
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts
the teeth of the main cam
cam groove of main cam
2. When fitting the OPT pinch relay gear
order as shown in Fig.3-15-2. The alignment of the
part is shown in Fig. A. Position the teeth of the OPT
pinch relay gear so that the sixth tooth space left of
part is aligned with the triangular mark on the
pinch cam gear . After aligning part
section 3-9-2 and check the positioning of the OPT
pinch relay gear, the pinch cam gear and the pinch lift
cam.
3. Align the hole in the crescent slide
the mechanism chassis, as shown at point
Fig.3-15-2 (refer to section 3-16 and see the
holes and in Fig.3-16-1).
4. When fitting the main cam
relay gear and the front rack gear
points and respectively in Fig.3-15-2.
5. When fitting the gear wheel 2
cam and the wheel gear 1
respectively in Fig.3-15-2.
, then remove the wheel gear 2
, then remove the main cam
, then remove the OPT pinch
, and
, and to the all over the
.
, align it in
, refer to
with the hole in
in
, position the OPT pinch
as shown at
, position the main
as shown at points
Main cam
.
Wheel
gear 2
, to
Front rack
gear
Crescent
slide
Pinch cam
gear
and
Front rack
gear
Main cam
Crescent
slide
–23–
Washer
OPT pinch relay gear
Clamp
Wheel gear 1
Fig. A
Align at
White line on the
MC-1 PWB assembly.
OPT pinch relay gear
Align the hole in the
main cam
shaft of the OPT pinch
relay gear .
Wheel gear 1
Clamp
Pinch cam
gear
Shaft
Shaft
Shaft
Fig.3-15-1
with the
Wheel gear 2
Fig.3-15-2