Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Control Handle
Position
There are two height positions for the control levers; high and
low. Remove the bolts to adjust the height for the operator.
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts installed in the levers
(Figure 60).
4. Align the levers front to rear position by bring the
levers together to the neutral position and slide them
until they are aligned, then tighten the bolts (Figure 61).
Figure 60
1. Bolt
2. Handle
3. Control lever
4. Nut
Adjusting the Motion Control
Linkage
Located on either side of the fuel tank, below the seat are
the pump control linkages. Rotating the pump linkage with a
1/2 inch wrench allows fine tuning adjustments so that the
machine does not move in neutral. Any adjustments should
be made for neutral positioning only.
WARNING
Engine must be running and drive wheels must
be turning so motion control adjustment can be
performed. Contact with moving parts or hot
surfaces may cause personal injury.
Keep fingers, hands, and clothing clear of rotating
components and hot surfaces.
1. Prior to starting the engine, push the deck lift pedal
and remove the height of cut pin. Lower deck to the
ground.
2. Raise the rear of machine up and support with jack
stands (or equivalent support) just high enough to
allow drive wheels to turn freely.
3. Move the seat the furthest rear position to expose the
front nuts.
4. Loosen the front nuts. The nuts do not need to be
removed.
5. Move the seat the furthest forward position to expose
the rear nuts.
6. Loosen the rear nuts. The nuts do not need to be
removed.
43
Figure 61
Advertisement
Table of Contents
