Operation - HAMOKI PG-SA Instruction Manual

Operation

▪ .
1. Before using, check whether the power supply installation is regular to make sure
the supplied voltage is coordinated.
2. Put the plug in the socket and turn on the power.
3. Turn the temperature controller clockwise to the temperature needed. The yellow
indicator will come on- this shows that the heating wire will begin to heat and the
upper and lower griddle will begin to rise in temperature.
4. Temperature can be adjusted according to different foods preferably within
180℃~250℃. About 8 minutes is needed for the temperature to be raised to 250℃
from the power is on.
5. When the temperature reaches 250℃, lift the upper module plate to a suitable
place by the handle. Put some vegetable oil on the lower module plate and place
the food on it. Close the plates and press the handle lightly. Keep an eye on the food
until it is suitably done.
6. When temperature reaches the setting degree, the temperature controller will cut
off the power supply automatically. At the same time,the yellow indicator will switch
off and the green indicator will come on. It shows that the electricity heating tube
has stopped.
7. At the lower front of the lower module is the oil tray. Substantial vegetable oil and
the animal oil from the meat grill will flow to the oil tray from the lower module plate.
8. Lift the upper module plate to take the sandwich and other food already done.
9. When the temperature is a bit lower, the temperature controller can get through
power supply automatically. The heating tubes will restart to work to heat the
module plates.
10. On completion of cooking, the temperature controller should be turned to the
"off" setting. Unplug the equipment and cut off the power.
11. There is a temperature limiter in the bottom box, the action temperature is 130℃,
and reset temperature is ‹40℃. When the temperature is higher than this, the
protective button will come on for warning. When using again, please press the
protective button to restart.
Cleaning and Maintenance:
1. Cut off the power supply before cleaning in case of accidents.
2. Do not use a wet towel with non-corrosive cleanser to clean the module plate, the
surface of the equipment or the power cord. Direct washing by water is not
permitted in case of any damage to the device-this can cause malfunction.
3. When not in use, please turn off temperature controller and main switch.
4. Please store the equipment in a ventilated area without corrosive gas after
cleaning.
For daily routine maintenance please check:
Before using:
Whether the machine is tilted?
Whether the power cord is old, broken or damaged?
Whether the control panel is damaged?
After using :
Whether there is strange smell?
3