Removing Or Installing The Blade; Operation - Makita PJ7000 Instruction Manual

Removing or installing the blade

8
4
► 1. Lock nut 2. Plate joiner blade 3. Inner flange
4. Clamp screw 5. Blade cover 6. Loosen 7. Tighten
8. Shaft lock
CAUTION:
• When installing the plate joiner blade, mount the inner
flange with the side marked "22" facing toward you.
To remove the blade, loosen the clamp screw and open the blade
cover. Push the shaft lock and loosen the lock nut using the lock
nut wrench. To install the blade, first mount the inner flange.
Then mount the blade and the lock nut. Securely tighten the
lock nut using the lock nut wrench. Close the blade cover and
tighten the clamp screw to secure the blade cover.
CAUTION:
• Use only Makita lock nut wrench provided to
remove or install the blade.
• Always check the depth of groove after replac-
ing the blade. Reajust it if necessary.
1
2
► 1. Dust bag 2. Fastener 3. Dust nozzle
To attach the dust bag, fit it onto the dust nozzle. If the
dust bag becomes an obstacle to your work, turn the
dust nozzle to change the dust bag position.
When the dust bag is about half full, switch off and
unplug the tool. Remove the dust bag from the tool and
pull the bag's fastener out. Empty the dust bag by tap-
ping it lightly to remove as much of the dust as possible.
NOTE:
• If you connect a Makita vacuum cleaner to your
plate joiner, more efficient and cleaner opera-
tions can be performed.
6
7
1
2
3
5
3

OPERATION

How to make joints
WARNING:
• Always clamp the workpiece to the workbench
before each operation.
Corner Joint (Fig. A)
6 ENGLISH
Fig. A