Table of Contents
Advertisement
4.2 Basic Instructions - Riser Mounting Bracket
Riser Mounting Kit (RMK) Contents:
D
B
Riser Mounting Kit (RMK) Mounting:
Ensure that the hooks are at the top when installed and that all three straps are fastened tight against
the riser (no slack).
Straps must be 90° angle to riser for proper installation.
IMPORTANT NOTE: Torque straps screws to 35 to 40 in - lbs.
4.3 Basic Instructions – QRM2- Mounting Bracket
1
2
B
A
D
C
The compressor comes factory mounted to the compressor bracket. NOTE: Each QRM2- model has
different mounting feet. Mounting holes for all compressors are provided on the QRM2- bracket.
IMPORTANT NOTE: Torque compressor mounting bolts to 12 ft - lbs
A
D
C
1 & 2 - Use the rectangular holes on the bracket to rest it on the riser plate hooks.
A, B, C, D - Securely fasten the QRM2- compressor bracket to the riser plate through the slots
using the hardware from the RMK (riser mounting kit). A socket extension may be required to insert
the bolts.
IMPORTANT NOTE: Torque bolts to 12 ft - lbs
Before mounting the compressor, check that the top surface of the QRM2- bracket is level and
parallel to the top edge of the riser plate.
A - Mounting Straps: Each RMK comes with 3 mounting straps.
B - Riser Mounting Plate
C - Nuts, Bolts, and Washers.
Necessary for mounting the QRM2- Bracket.
D - Mounting Hooks
Bring the mounting straps in from the back side
through the left hole. Pass over the front of the
Plate and put the strap through the right. Repeat
for straps 2 and 3.
5
Advertisement
Table of Contents
