Samsung WD10K6 Series User Manual page 57

Problem
OC
LC
LC1
FC
UB
3C
UC
WD10K6410OX_03745V-00_EN.indd 57
Water is overflowed.
• Restart after spinning.
• If the information code remains on the display, contact a local
Samsung service centre.
Check the drain hose.
• Make sure the end of the drain hose is placed on the floor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the "LC"/"LC1" code, the washer
do draining for 3 minutes. During this time, the Power
button is inoperative.
Check the fan motor.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Spinning does not work.
• Make sure laundry is spread out evenly.
• Make sure the washing machine is on a flat, stable surface.
• Redistribute the load. If only one item of clothing needs
washing, such as a bathrobe or pair of jeans, the final spin
result might be unsatisfactory, and an "UB" check message
will be shown in the display.
Check the Motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service
centre.
The electronic control needs to be checked (Over Voltage Error).
• Check the PCB and wire harness.
• Check if power is supplied properly.
• If the information code remains, contact a customer service
centre.
Low voltage detected
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service
centre.
Action
English 57
2016/12/23 14:54:40