Troubleshooting - Panasonic EH-HV52 Operating Instructions Manual

Troubleshooting

Problem
After pressing the Power Switch, the LED
Temperature Level Display does not blink.
The temperature is not changed even
though the Temperature Level Adjustment
Switch is pressed.
During use, the unit gives off a burning smell.
If the Power cord is bent or twisted,
sometimes the power turns off.
All the LED Temperature Level
Displays blink.
It takes time to reach operating temperature.
If problems still cannot be solved, contact the store where you purchased the unit or a service center authorized by Panasonic
for repair.
16
Possible cause
The length of time you pressed the
Power Switch was not enough.
The Temperature Level Adjustment
Switch has been locked.
Dust etc. are adhered to the Iron Plate.
The time to reach operating
temperature (approximately 100 °C)
differs depending on the area.
100 - 130 V: about 45 seconds
220 - 240 V: about 15 seconds
Action
Press and the hold the Power
Switch for approximately 1
second to turn on the
straightener.
Press the Temperature Level
Adjustment Switch "-" 2 times.
Clean the Iron Plate to remove
any adherents.
Stop using immediately.