Advertisement
Mount the rear feet on the BeoSound and make sure the front feet are mounted, unless you want to use the wall bracket.
Place BeoSound 8 on a flat, stable surface, connect the power cable and dock your iPod/iPhone/iPad™.
Your iPod/iPhone/iPad is charged when connected.
As well as listening to music stored on your iPod/iPhone/ iPad, you can use your BeoSound 8 to:
For more information see the BeoSound 8 section under: www.bang-olufsen.com/faq
You must adjust the part of the docking station that supports your iPod/iPhone/iPad by turning the round back part (left or right). Align the front of the iPod/iPhone/ iPad with the front of the BeoSound.
Adjust the part of the docking station that supports your iPhone/ iPod/iPad.
To dock and undock your iPhone/ iPod/iPad safely you must use a parallel upwards or downwards movement aligned with the part of the docking station that supports your device.
Never use force and never tilt your iPhone/iPod/iPad when you dock/ undock.
The light is green when the BeoSound is switched on. It is orange when playback is paused or muted. When the BeoSound is switched to standby, the light flashes red once.
Browse and select music from your digital music collection directly on the iPhone/iPod/ iPad. Use the operation panel or the dedicated remote to perform basic operation.
The dedicated remote control can be used in the same way as the operation panel on the BeoSound.
Play/Pause
Press and hold for standby
Press and hold for more than 5 seconds for 'deep sleep'*
*In 'deep sleep', the power consumption is very low, however a docked iPod/iPhone or iPad is not charged. This function can only be obtained by close-up operation.
A Beo4 or Beo5/Beo6 remote control can also be used, see the BeoSound 8 section under www. bang-olufsen.com/faq for more information.
To access the connection panel, you must remove the back cover. Pull out the cover at the bottom to release the locks, then lift it off.
The approval labels are placed behind the back cover.
Priority of connections;
This means that AUX cannot be activated if an iPod/iPhone/iPad is connected, or other equipment is connected via USB
Power input socket (right side)
Use the enclosed mains cord only.
Mini-USB socket
For connection to a computer.
AUX
Phono sockets for connection of, for example, an MP3 player. Can also be used for connection to the AirPort Express to allow for wireless transmission of iTunes music to the BeoSound.
For safety reasons fasten the mains lead behind the small peg, before running it out from the connection panel.
Position switch (left side)
Free
Use this setting if the BeoSound is placed on a table or shelf not close to a wall.
Wall
Use this setting if the BeoSound is placed close to the wall, for example mounted on the wall bracket.
Corner
Use this setting if the BeoSound is placed in a corner.
Wipe dust off the surfaces using a dry, soft cloth. Do not use liquid cleaners or aerosol cleaners. To remove stains or dirt, use a soft, damp cloth and a solution of water and mild detergent, such as washing-up liquid.
Technical specifications, features and the use thereof are subject to change without notice.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the BeoSound 8 that isn't answered in the manual? Leave your question here.