Philips MULTIGROOM 5000 Series Manual page 14

ENGLISH
14
Problem
The combs do not
stay attached to the
handle.
The appliance does
not work anymore.
The appliance does
not charge when it
is connected to the
mains.
The appliance does
not trim as well as it
used to.
The appliance
becomes hot.
Troubleshooting
Possible cause
You do not attach
the comb correctly.
The guiding grooves
are dirty.
The comb is broken.
The rechargeable
battery is empty.
The appliance has to
be switched off when
you charge it.
The cutting element
of the attachment
you are using is dirty.
The cutting element
of the attachment
you are using is dirty.
Solution
Slide the comb into the guiding grooves on both sides
of the handle until you hear a click.
Clean the appliance and the guiding grooves thoroughly.
Go to your Philips dealer or contact a Philips service
centre to purchase a new comb.
Charge the appliance (see chapter 'Charging'). Make sure
you switch off the appliance before you charge it. During
charging, the charging light on the adapter flashes.
If the charging light does not flash, check whether there
is a power failure or if the wall socket is live. If there
is no power failure and the wall socket is live but the
charging light still does not flash, take the appliance to
your dealer or a Philips service centre.
Switch off the appliance.
Remove the attachment from the appliance. Clean the
attachment under a lukewarm tap.
Remove the attachment from the appliance.
Clean the attachment under a lukewarm tap.