Faber FCK 101 Instruction Manual page 6

pressing the lid release button, fill with the desired amount of water,
and then close the lid. Alternatively, the kettle may be filled through
the spout. The water level should not exceed MAX marks or sit below
MIN level. Too little water will cause the kettle switching off before the
water has boiled.
NOTE: Do not fill the water over the maximum level, as water
may spill out of the spout when boiling. Ensure that the lid is
firmly in place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off switch,
the indicator will light up. Then the kettle will start to boil the water,
once the water has being boiled the On/Off switch will be off
automatically. You can shut off the power by lifting the On/Off switch
at any moment during boiling water. If you want to boil water again,
only press down the On/Off switch directly to restart the kettle.
NOTE: Ensure that the On/Off switch is free of obstructions and
the lid is firmly closed, the kettle will not turn off if the switch is
constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your
kettle as boiling water may result in scald, besides, don't open
the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the On/Off switch is pressed down
5