Initial Setup; Turntable Operation - Crosley T100A Instruction Manual

English

Initial Setup

Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Place the slip mat on top of the turntable platter.
4. Use the Speaker Wire to connect the left and right speakers' Input Terminals
to the turntable's Output Terminals correspondingly. Make sure the left and
right channels are connected correctly.
5. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Stereo System Connection
RCA Jacks
• The RCA Jacks output analog line-level signals and could be connected
directly with a pair of active/powered speakers or the appropriate input of your
stereo system.
• The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered
speakers. If connected to the passive speakers, the volume level will be very low.

Turntable Operation

1. Press the Power Switch to turn on the power.
2. Rotate the Function Knob to either 33
turntable speed accordingly. Use the 45 RPM Adapter if necessary
3. Place the record on the turntable.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
5. Lift up the Tonearm and move it over the record where play is desired to
begin. Gently put down the Tonearm and begin the playback.
6. When the record is finished playing, gently lift up the Tonearm and move it
back to the Tonearm Rest. To suspend the playback, repeat the same steps.
1
/ or 45 RPM mode to select the
3
5