Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Crosley T300A-SI
Summary of Contents for Crosley T300A-SI
- Page 1 T300A-SI Blue tooth turntable NSTRUCTIONMANUAL ...
-
Page 2: Important Safety Instructions - Read Carefully Before Use
Safety instructions IMPORTANT SAFETY INSTRUCTIONS - READ CAREFULLY BEFORE USE This symbol indicates that there are important operating maintenance instructions in the user manual accompanying this tablet. This symbol indicates that dangerous voltage is present within this tablet, constituting a risk of electric shock or personal injury. -
Page 3: Fcc Caution
FCC statement in User’s Manual (for class B) Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the Instructions , may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‐Reorient or relocate the receiving antenna. ‐Increase the separation between the equipment and receiver. ‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.‐Consult the dealer or an experienced radio/TV technician for help. FCC Caution: 1. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. This device and its antenna(s) must not be co‐located or operating in conjunction with any other antenna or transmitter. ... - Page 4 IMPORTANT NOTE : (For MobileDevice Configuration) FCCRadiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. ...
- Page 5 Assembly Drive belt: The belt and turntable platter have been installed properly at factory, if the belt is loose during transportation, install it as below: Remove the rubber mat from the turntable platter and the E ring from the turntable shaft, then release the turntable platter from the shaft Put the drive belt on the inner rim of the turntable platter and pull it through the hole Hold the belt with your fingers and place the belt onto the motor pulley...
- Page 6 FEATURES 45RPM Adaptor: Use this adaptor when playing 45 RPM records. Switch 33 or 45 rpm for playing a record at a correct speed. Pick-up arm stand Pick-up Arm Lift Stick: To raise up and down the Pick-up Arm and cue at a proper place of a vinyl.
-
Page 7: Bluetooth Connection
Power LED: It’s light while the unit is turned on. Volume control: To adjust the volume of headpone and Blue tooth output. 10. Reject Press it to force the arm to return directly to the arm rest 11. RCA Line Out Cable Connect the RCA line out to a mixer or an amplifier 12. -
Page 8: Basic Operation
Press the Blue‐Tooth switch for 2 seconds for pairing to speaker, the LED will twinkling fast. Once the bluetooth connect to a speaker, the LED is light. Press the Blue‐Tooth switch for 2 seconds to disconnect the paired connection, and the LED is off While the bluetooth is connected with a speaker, if the speaker is switched off or out of the available area, the blue tooth of turntable will be in standby mode, and the LED is twinkling. Once the speaker is available for connection, it will be automatically connected. REMARK: Some speakers have limited blue tooth access that may have problem for wirelessly connecting to this turntable. If it takes long time for bluetooth connecting to this turntable, please disconnect it, and shift to connect the speaker with mobile phone via blue tooth, to activate the speaker’s bluetooth system. After it, close the bluetooth of mobile phone, and connect the speaker to turntable again. Basic Operation Remove the cover of cartridge Release the tonearm clamp. Lift the tonearm, and move it to the center of vinyl to re-set the auto return mechanism, and then return it to arm-rest. - Page 9 Switch off the power, if you do not play it. ...
Need help?
Do you have a question about the T300A-SI and is the answer not in the manual?
Questions and answers