Sony QM-SS1 Help Manual page 30

Help Guide
Mobile Motion Capture
QM-SS1
Sending motion data to an external device
Send motion data to an external device with the mocopi app.
Connect your smartphone to an external device.
1
On the motion capture screen, tap [Motion].
2
Tap [SAVE/SEND] to select [SEND].
3
The icon used to send data to an external device appears in the record button (green).
Tap the record button (green) to start motion capture.
4
Motion data transmission starts after the countdown.
Tap the record button (green) to stop the motion capture.
5
Motion data transmission stops.
Note
If data cannot be communicated to an external device, check for the following.
The IP address, outbound port settings and transfer format set on the [PC connection settings] screen are correct.
Data reception at the specified port number (UDP) is not being blocked by a firewall, etc. on the external device.
Record button on the screen
The record button on the screen changes as follows according to the shooting mode.
(Start recording button)
(Stop recording button)
Related Topic
Overview of the motion capture screen
Setting up an external device
Recording in Motion mode
H-242-100-11(1) Copyright 2023 Sony Corporation
30
TP1001055232