Installing The Sensors - Sony QM-SS1 Help Manual

Help Guide
Mobile Motion Capture
QM-SS1

Installing the sensors

Refer to [Straps and sockets] on the [Securing the sensors] screen to see the strap type.
1
Set the sensor onto the socket.
2
Hold the sensor close to the socket. The built-in magnet fits the sensor into the correct position on the socket, and
the sensor is locked into place on both sides by the clips (A). You can check if the sensor is set correctly on the
socket by seeing whether the marks on the side (B) are aligned.
Once all the sensors are installed and secured in place on the sockets, tap [NEXT] on the [Securing the
3
sensors] screen.
The [Attaching the sensors] screen appears.
Hint
All the sensors can be installed in the same way.
Note
Before installing the sensors, make sure that there is no dust or foreign material adhered to the sensors or the sockets.
After installing the sensors, make sure that the sensors are not rotated on the sockets and that the clips of the sockets are locked
in place. If the sensors are not secured properly, they may fall off during motion capture and become damaged or harm those in
your surroundings.
Related Topic
15