Front; Remote Control Operating Range; Remote Control Battery Installation - Sanyo PLV-Z3000 Owner's Manual

Part Names and Functions

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing any buttons. Maximum operating
range for the remote control is about 16.4' (5 m) and 60 degrees in front of the projector.

Remote Control Battery Installation

Open the battery
1
compartment lid.
Pull up the lid
and open it.
* When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 1) (p.41).
To ensure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
12
16.4'
(5 m)
30°
30°
Remote control
Install new batteries
2
into the compartment.
3
Two AA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Replace the compartment lid.