Advertisement

Quick Links

ROCKET®
Cordless Vacuum
QZ160HQ Series
OWNER'S GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROCKET QZ160HQ Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Shark ROCKET QZ160HQ Series

  • Page 1 ROCKET® Cordless Vacuum QZ160HQ Series OWNER’S GUIDE...
  • Page 2: Important Safety Instructions

    These components contain electrical mothproofing substances, or temperatures below 37.4°F (3°C) or connections, electrical wiring, and 12. Only use Shark® branded filters and GUIDE flammable dust) above 104°F (40°C) to maintain long- moving parts that potentially present risk accessories..
  • Page 3: Li-Ion Battery

    RECYCLING THE LI-ION BATTERY When your Shark Li-Ion battery needs to be replaced, dispose of it or recycle it in accordance with local ordinances or regulations. In some areas, it is illegal to place spent lithium-ion batteries in the trash or in a municipal solid waste stream.
  • Page 4: Charging The Battery

    SETTINGS CHARGING THE BATTERY USING THE LI-ION CHARGER SETTING I Bare Floor/Small Area Rugs Slide switch to the bottom to turn off power. LI-ION CHARGER IN THE VACUUM: STANDARD WAND To begin vacuuming in Standard Mode, slide switch The brushroll spins slowly to clean bare floors and to the desired setting.
  • Page 5: Cleaning Modes

    CLEANING MODES USING THE MULTIFLEX ® WAND UPRIGHT MODE Press the unlock latch on the back of the wand, Adjust the wand to a lower angle to easily clean To clean floors, place foot on floor nozzle and tilt handheld vacuum back. then adjust the angle.
  • Page 6: Maintaining Your Vacuum

    MAINTAINING YOUR VACUUM MAINTAINING YOUR VACUUM EMPTYING THE DUST CUP CLEANING THE FILTERS To clean filters, rinse them with water only. Allow all filters to air-dry completely for at least 24 hours before reinstalling to prevent liquid from being drawn into electric parts. Clean the pre-motor filters at least once a month and post-motor or HEPA filter at least once a year.
  • Page 7: Maintenance

    MAINTAINING YOUR VACUUM MAINTENANCE FLOOR NOZZLE FLOOR NOZZLE CHECKING FOR BLOCKAGES If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or Checking for Blockages in the Handheld Vacuum: objects caught in the brushroll. 1.
  • Page 8: Troubleshooting

    MAINTAINING YOUR VACUUM ADDITIONAL ACCESSORIES AVAILABLE ON SHARKACCESSORIES.COM TROUBLESHOOTING 8" Crevice Tool WARNING: To reduce the risk of shock and unintended operation, turn off 18" Flexi Crevice Tool power and remove the Li-Ion battery before servicing. Duster Crevice Tool Dusting Brush Vacuum is not picking up debris.
  • Page 9: Five (5) Year Limited Warranty

    FIVE (5) YEAR LIMITED WARRANTY TWO (2) YEAR LIMITED BATTERY WARRANTY The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja The Two (2) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC.
  • Page 10: Technical Specifications

    NOTES REGISTER YOUR PURCHASE registeryourshark.com RECORD THIS INFORMATION TECHNICAL SPECIFICATIONS Voltage: 21.6V Model Number: ����������������������������� Date Code: ��������������������������������� Watts: 181W Date of Purchase: ��������������������������� Amps: 8.4A (Keep receipt) Store of Purchase: ��������������������������� TIP: You can find the model and serial numbers on the QR code label on the bottom of the back of the handheld vacuum and battery.
  • Page 11 For SharkNinja U.S. Patent information, visit sharkninja.com/uspatents © 2020 SharkNinja Operating LLC. MULTIFLEX, ROCKET, and SHARK are registered trademarks of SharkNinja Operating LLC. DIRT ENGAGE is a trademark of SharkNinja Operating LLC.

Table of Contents