Unfolding The Handle - Toro 21621 Operator's Manual

3

Unfolding the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cable(s) when folding or unfolding the handle.
• Ensure that the cable(s) are routed to the outside of the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
Important:
Remove and discard the protective plastic sheet that covers the motor and any other
plastic or wrapping on the machine.
1. Remove the handle knobs (A of
2. Using the holes at the ends of the handle, attach the handle to the machine (B of
3. Move the handle rearward to the operating position (C of
4. Ensure that the cables are routed in front of the handle (D of
5. Engage the handle locks until the pin clicks in place to lock the handle into the operating position (E of
Figure 5).
Note:
You may adjust the height of the handle by changing the hole for the handle lock.
6. Secure the knobs to the handle bolts to secure the handle (F of
Figure 5).
10
Figure 5).
Figure 5).
Figure 5).
Figure 5).