Logitech 9923 Setup Manual page 12

Press the button you want to set as the dual clutch button

The only valid buttons for this are the left stick button (LSB)

and right stick button (RSB) The RPM LEDs will flash red

to show that you're in clutch position setting mode

While in your chosen simulation or game with the car still on

a track, fully depress the clutch and gas pedals Engage first

gear and keep pressing the minus button down until the car

begins to move in-game You can adjust the precise bite

point of the clutch by using the plus and minus buttons until

you are happy with the setting

At this point you may test the dual clutch without

leaving the setting mode It is recommended you attempt

a race start, stop the car and adjust the bite point and

then try again until you are satisfied with the performance

of the dual clutch

Press the Select button in the middle of the dial on the wheel

to exit dual clutch setting mode The RPM LEDs will flash

in a sequence from green to blue to show that the setting

is saved The RPM LEDs will then go out and begin responding

again to RPM output from supported games

11 ENGLISH