Volvo V90 TWIN ENGINE 2017 Owner's Manual page 488

STARTING AND DRIVING
|| 3. Do not release the buttons until the indicator
lamp has switched from flashing slowly
(approx. once per second) to either flashing
quickly (approx. 10 times per second) or illu-
minating with a constant glow.
> If it illuminates with a constant glow:
Indication that the programming has fin-
ished. Press the programmed button
twice to activate.
If it flashes quickly: The device to be
programmed to HomeLink
security function that requires extra steps.
Test by pressing the programmed button
twice to see whether the programming is
working. Otherwise, continue with the fol-
lowing steps.
12 Button designation and colour varies between manufacturers.
Note that the toll-free number may not be available depending on operator.
13
486
4. Locate programming button
®
may have a
receiver for the garage door or similar. It is
normally located close to the antenna's
bracket on the receiver.
5. Depress and release the receiver's program-
ming button once. The programming must be
completed within 30 seconds of the button
being depressed.
6. Press and release the button on HomeLink
that you want to program. Repeat the
sequence of pressing/holding/releasing a
second time and, depending on the receiver
model, even a third time.
> Programming is now be complete and the
garage door, gate or similar should now
be activated when the programmed but-
ton is depressed.
In the event of programming problems, contact
®
HomeLink
12
on the
at www.HomeLink.com,
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll number +49 6838 907 277)
Reprogramming individual buttons
To reprogram an individual HomeLink
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2. Once the indicator lamp on HomeLink
starts to flash slowly, programming can con-
tinue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved programming.
Resetting the HomeLink
It is only possible to reset all of the HomeLink
®
buttons at the same time, not each button indi-
vidually. Individual buttons can only be reprogram-
med.
– Press and hold depressed the outer buttons
(1 and 3) on HomeLink
onds.
> When the indicator lamp changes over
from a constant glow to starting to flash,
the buttons are reset and ready to be
reprogrammed.
13
.
®
button,
®
®
buttons
®
®
for approx. 10 sec-