Table of Contents
Advertisement
en
Rails
Final cleaning
Open the appliance door and remove the remaining
1.
water with an absorbent sponge cloth.
Clean the smooth surfaces in the cooking
2.
compartment with a dish cloth or a soft brush.
Stubborn residues can be removed using a stainless
steel scouring pad.
Remove limescale with a cloth soaked in vinegar.
3.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
Use the # touch button to switch off the appliance.
4.
Leave the appliance door ajar in the locking position
5.
(approx. 30°) for approx. 1 hour to allow the enamel
surfaces in the cooking compartment to dry.
Alternatively, you can also run the rapid drying
function for the cooking compartment.
Running the rapid drying function for the cooking
compartment
After the cleaning aid process has finished, leave the
1.
appliance door ajar in the locking position (approx.
30°).
Touch the # touch button.
2.
Start CircoTherm hot air at 50 °C.
3.
After 5 minutes, switch off the appliance and close
4.
the appliance door.
Removing heavy deposits of dirt
You have several options for removing particularly
stubborn deposits of dirt.
Leave the soapy water to work for some time before
■
starting the cleaning aid.
Rub soapy water onto the dirt on the smooth
■
surfaces before starting the cleaning aid.
Repeat the cleaning aid once the cooking
■
compartment has cooled down.
22
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Lift the rail slightly at the front ‚ and detach it ƒ
1.
(figure
!
).
Then pull the whole rail towards you and take it out
2.
(figure
"
).
Clean the rails with
cleaning agent and a sponge. For stubborn deposits of
dirt, use a brush.
Attaching the rails
The rails only fit on the right or the left side. For both
rails, ensure that the retaining bracket is at the front.
First, insert the rail in the middle of the rear socket ‚,
1.
until the rail rests against the cooking compartment
wall, and push it back ƒ (figure
Then insert the rail into the front socket „, until the
2.
rail also rests against the cooking compartment wall
here, and press it downwards ... (figure
!
).
"
).
Advertisement
Table of Contents
