Connection To Water Supply; Connecting To Hot/Cold Water Supply - Asko WM75 C-V Series User Manual

(See chapter TRANSPORT PROTECTION.)

Connection to water supply

INFORMATION!
The machine has to be connected to water supply by an adequately trained person.
Use the water supply hose to connect the appliance. Water pressure has to be between 0.1 and 1
MPa (approximately 1 10 kp/cm
If the hoses are newly installed, we recommend rinsing them to remove any impurities. Otherwise,
these impurities could clog the filter in the water connection on the washing machine and thus cut
off the water supply.
The water intake hose has to be fastened firmly enough for the hose to have a good seal.
After connecting the hose, the seal must be checked for any leaks.
Only use the water supply hose supplied with the appliance. Do not use any used or other hoses.
A single check valve is included in the Set of documents, which must be installed to the cold water
supply hose (UK only).
INFORMATION!
If the connection on the supply hose is of different dimensions than the water tap (e.g. 3/4" →
1/2"), use an adapter.

Connecting to hot/cold water supply

(Only available in some models)
If your appliance has connections for both hot and cold water, then connect one hose to the cold
water connection and the other hose to the hot water connection, as indicated on the back of the
appliance:
COLD = cold and HOT = hot.
Hot water is supplied for programs operating at 40 °C or more.
Installation and connection
2
, 1-10 bar, 10 100 N/cm
2
).
15