Table of Contents
Advertisement
5.
On your motherboard, press the BIOS FlashBack™ button for three seconds until the
FlashBack™ LED blinks three times, indicating that the BIOS FlashBack™ function is
enabled.
Refer to section 1.1.8 Onboard LEDs for more information of the FlashBack™ LED.
If the system fails to boot after flashing the BIOS, unplug the power core and restart the
system.
6.
Wait until the light goes out, indicating that the BIOS updating process is completed.
For more BIOS update utilities in BIOS setup, refer to the section 3.11 Updating BIOS in
Chapter 3.
•
Do not unplug portable disk, power system, or press the CLR_CMOS button while
BIOS update is ongoing, otherwise update will be interrupted. In case of interruption,
please follow the steps again.
•
If the light flashes for five seconds and turns into a solid light, this means that
the BIOS Flashback is not operating properly. This may be caused by improper
installation of the USB storage device and filename/file format error. If this scenario
happens, please restart the system to turn off the light.
•
Updating BIOS may have risks. If the BIOS program is damaged during the process
and results to the system's failure to boot up, please contact your local ASUS Service
Center.
ASUS WS C422 SAGE/10G
2-13
Advertisement
Table of Contents
