Advertisement
If your model have
Always use salt intended for use with dishwasher.
The salt container is located beneath the basket and should be filled as follows:
Attention!
Only use salt specifically designed for use in dishwashers! All other types of
salt not specifically designed for use in a dishwasher, especially table salt, will
damage the water softener. in case of damages caused by the use of unsuitable
salt the manufacturer does not give any warranty nor is liable for any caused
damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, w hich may have been split,
remaining of the bottom of the machine for any period of time, w hich may cause
corrosion.
A
Remove the basket and then unscrew and remove the cap from the salt container.
B
Before first wash, add 1lt. of water in the salt container of your machine.
C
Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
It is
normal for a small amount of water to come out of the salt container.
D
After filling the container , screw the cap tightly back clockwise.
E
Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled with
salt.
F
Immediately after filling the salt into the salt container, a washing programme should be started
Otherwise filter system, pump or other important parts of the machine may be damaged by salty
water. It is out of warranty.
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the salt warning light may still be on even though the
salt container is filled.
If there is no salt warning light in the control panel (For some Models),you can judge when to load
the salt into the softener by the cycles that the dishwasher had run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Adjusting Salt Consumption
Step 1: Enter the status of salt adjustment
Close the door, within 60 seconds after power on, press Start/Pause button and hold for 5 seconds,
the machine will enter setting mode.
no
water softener, you may skip this section.
4
Advertisement
