Philips PAB90 1 Series Getting Started Manual page 6

As already mentioned in the overview, the PAB90x-1 programming board is
designed as an add-on board to the MCB900 board from Keil Software. Before any
P89LPC90x devices can be programmed, the LPC932 microcontroller on the Keil
MCB900 board needs to be programmed with the ISP-ICP bridge code using the
ISP software FlashMagic (included on the CD). FlashMagic then also supports the
programming of P89LPC90x devices, however only in combination with the
ISP-ICP bridge code on the MCB900 as noted above.
Step 1) Install FlashMagic from the included CD
Go to folder "FlashMagic" on the included CD ROM and execute "FlashMagic.exe".
Follow the instructions to install FlashMagic.
(The latest version of FlashMagic can always be found at
www.esacademy.com/software/flashmagic)
Step 2) Program the LPC932 device on the MCB900 board with the ISP-ICP
bridge code using the FlashMagic software you installed in step 1
The ISP-ICP bridge code is included on the CD (folder "ISP ICP bridge source
code").
• Set the jumper on the MCB900 board to the RESET position:
Reset mode LPC932
PAB90x-1 Getting Started V1.0 Page 6