Philips PAB90 1 Series Getting Started Manual page 11

• At this point you can do a quick read of the device signature bytes to make
sure you're connected to the LPC90x:
If FlashMagic cannot read the Device Signature or you get all FF's, please
check your setup. The correct signature bytes are:
LPC901: 15h DDh 0Dh; LPC902: 15h DDh 0Fh; LPC903: 15h DDh 10h
Step 2.
Select which Flash blocks should be erased before the programming operation.
Step 3.
Select the hex file to be programmed.
Step 4.
Can be used to set security bits and fill unused Flash (optional)
Step 5.
Start programming!
"Hello World" Example
Provided on the CD provided is some example code for the LPC903, which uses
the UART to send out the string "Hello World : )". (Only the LPC903 has a UART.)
The example code can be programmed using the 5 steps described above.
To run the user code after you programmed it, please refer to section 4.
PAB90x-1 Getting Started V1.0 Page 11