Before First Use; Daily Use - Zanussi ZFC21410WE User Manual

Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature Regulator to the Full
Loaded position and let the appliance run
for 24 hours to allow the correct
temperature to be reached before placing
food inside.
The power indicator light will light up.
3. Adjust the Temperature Regulator
according to the quantity of the stored
foods.
Switching off
Turn the Temperature regulator to the OFF
position.
Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as follows:
• to obtain the minimum coldness, turn the
Temperature Regulator toward lower
settings.

Before first use

WARNING!
Refer to Safety chapters.
Cleaning the interior
Before using the appliance for the first time, the
interior and all internal accessories should be
washed with lukewarm water and some neutral

Daily use

WARNING!
Refer to Safety chapters.
www.zanussi.com
A) Temperature Regulator
B) Half Loaded position
C) Full Loaded position
A
B
C
• to obtain the maximum coldness. turn the
Temperature Regulator toward higher
settings.
High temperature alarm
An increase in the temperature in the freezer
(for example due to an power failure) is
indicated by:
• switching on of the Alarm light
• sounding of buzzer
During the alarm phase, the buzzer can be
switched off by pressing the Alarm reset switch.
During the alarm phase, don't place food inside
the freezer.
When normal conditions are restored the Alarm
light will switch off automatically.
soap to remove the typical smell of a brand-new
product, then dried thoroughly.
In case of freezing less food
volumes, the Half Loaded setting is
the most suitable. In case of freezing
much food volumes, the Full Loaded
setting is the most suitable.
CAUTION!
Do not use detergents or abrasive
powders, as these will damage the
finish.
5