Configuring Router; Connecting To Web-Based Interface - D-Link DSL-2740U Quick Installation Manual
Wireless adsl2+ router with ethernet wan support
Hide thumbs
Also See for DSL-2740U:
- User manual (174 pages) ,
- Quick installation manual (25 pages) ,
- Setup manual (4 pages)
Table of Contents
Advertisement
DSL-2740U
CONFIGURING ROUTER
Connecting to Web-based Interface
Start a web browser. In the address bar of the web browser, enter the IP
address of the router (by default, the following IP address is specified:
192.168.1.1). Press the Enter key.
If the error " The page cannot be displayed " (or " Unable to display the
!
page "/" Could not connect to remote server ") occurs upon connecting to
the web-based interface of the router, make sure that you have properly
connected the router to your computer.
If the device has not been configured previously or the default settings have
been restored, after access to the web-based interface the Initial Configuration
Wizard opens (see the Initial Configuration Wizard section, page 18).
Quick Installation Guide
14
Advertisement
Table of Contents
