Toro Groundsmaster 4000 Series Installation Instructions page 3

Figure 3
1. Spring pin
2. Snap ring
3. Rubber cushion
4. Plate
5. Deck mount
6. Locknut (3/4 inch)
Figure 4
1. Installed deck mount
7. Spacer
8. Bolt (3/4 x 4-1/2 inches)
9. Bolt
10. Lock washer
11. Washer
10. Install the U-joint caps and secure them with the
previously removed snap rings
11. Install the hydraulic cylinder to the deck mount
with a bolt (3/4 x 4-1/2 inches), locknut (3/4
inch), and spacers
(100 ft-lb).
12. Install the cable tie
g365599
1. Cable tie
13. Start the machine and check the operation of
the cutting unit. Ensure no hoses rub against
the machine and if needed, adjust the hoses.
g365601
3
(Figure 3).
(Figure 3); torque to 136 N∙m
(Figure 5).
Figure 5
g365600