Off-Season Storage - Craftsman 247.772460 Operator's Manual

If the edger will not be used for 30 days or longer, the equipment needs to be stored properly. Follow storage instructions below to ensure top
performance from the edger for many more years.
PRePARiNg THe eNgiNe
Engines stored over 30 days need to be drained of fuel to prevent
deterioration and gum from forming in the fuel system or on essential
carburetor parts. If the gasoline in your engine deteriorates during
storage, you may need to have the carburetor, and other fuel system
components, serviced or replaced.
1. Remove all fuel from the tank by running the engine until it stops.
2. Change the engine oil.
3. Remove the spark plug and pour approximately 1 oz. (30 ml) of
clean engine oil into the cylinder. Pull the recoil starter several
times to distribute the oil, and reinstall the spark plug.
4. Clean debris from around the engine, and under, around, and
behind the muffler. Apply a light film of oil on any areas that are
susceptible to rust.
5. Store in a clean, dry and well ventilated area away from any
appliance that operates with a flame or pilot light, such as a
furnace, water heater or clothes dryer. Avoid any area with a spark
producing electric motor, or where power tools are operated.
6. If possible, avoid storage areas with high humidity.
7. Keep the engine level in storage. Tilting the engine can cause
fuel or oil leakage.

OFF-SEASON STORAGE

PRePARiNg edgeR
If the edger will not be used for 30 days or longer, follow the instruc-
tions below.
1.
2.
3.
4.
NOTE: When storing any type of power equipment in an poorly
ventilated or metal storage shed, care should be taken to rustproof the
equipment.
18
Store the edger in a dry, clean area. Do not store next to any
corrosive materials, such as lawn fertilizer.
Coat the edger blade with chassis grease to prevent rusting and
corrosion.
Coat the edger, especially any springs and bearings with a light
oil or silicone spray.
Clean the exterior of the engine and the edger.