Connecting An Am(Mw)/Lw Aerial; Connecting An Fm Aerial - Samsung MM-N4 Instruction Manual

Connecting the AM(MW)/LW Aerial
The AM(MW)/LW aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are
marked AM.
To avoid noise interference, check that the loudspeaker wires do not run
close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
ANTENNA
AM
FM (75 )
Connecting the FM Aerial
There are two types of aerials, follow the instructions below
(depending on option chosen).
1
How to connect a COAXIAL TYPE areial.
Connect a 75Ω antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 8 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear
of the system, using a 75Ω coaxial cable (not supplied).
2
How to connect a SCREW TYPE wire aerial.
The FM aerial connector terminals are located on the rear of the
system and marked FM(75Ω).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
FM FM
FM AERIAL 75Ω COAXIAL CABLE
(not supplied)
(supplied)
5
GB