Advertisement
General instructions for use
1. A first‑time user should, as a minimum, practice
cutting logs on a saw‑horse or cradle.
2. Before first use, fill Oil Reservoir to just below neck
with included bar and chain oil. Oil is automatically
applied to the Saw Chain during operation.
3. Periodically during use, check the Oil Level
Window to monitor oil usage. Add oil as needed.
nOtice: tO preVent prOperty
DaMaGe: Do not run Chainsaw without oil.
4. Make sure that the Trigger is in the off‑position,
then slide the Battery Pack into slot on back
of Chainsaw until it clicks into place.
5. Grasp the Front and Rear Handles with both hands.
always hold the chain saw with your right
hand on the rear handle and your left hand on
the front handle. Always grip the Handles with
the thumb and fingers encircling the handles.
use this grip,
thumb below
handle
note: Front Hand Guard not shown.
Item 64940
For technical questions, please call 1-888-866-5797.
6. Stand in front of the wood to be cut
with your feet firmly in place.
7. Push the Trigger Lockout in, squeeze and hold
the Trigger, then release the Trigger Lockout.
Release Trigger to turn off Chainsaw.
DanGer! tO preVent SeriOuS inJury
anD DeatH FrOM KicKBacK: Do not
touch the Guide Bar nose to the wood.
8. When the Chainsaw reaches full speed, begin
cutting with a light, downward pressure against
the bottom mid‑section of the Saw Chain.
Allow the Saw Chain to cut at its own rate.
Applying too much pressure can damage the tool.
DanGer! tO preVent SeriOuS inJury
anD DeatH: When cutting loose, round
wood stock, place the wood stock on a sawhorse,
in a cradle, or in a timberjack (all sold separately)
to avoid grabbing and throw back.
9. To prevent accidents, turn off the tool and
remove its Battery Pack after use.
10. When the Chainsaw has cooled completely,
clean thoroughly and cover the Guide Bar
with the Chain / G uide Bar Sheath.
Store the tool indoors out of children's reach.
Page 17
Advertisement
