Installing Nylon Line Cutter - Echo GT-2150 Operator's Manual

Nylon line comes out
(1)
Tap knob of spool
(2)
GT-2150/2150S

INSTALLING NYLON LINE CUTTER

Tap knob of spool
Hit knob against the
ground surface lightly
Housing
Spool
Cover (3)
NYLON LINE HEAD
Type : F-4/8R
Thread : M 8 × 1.25
ADJUSTING NYLON LINE
• Make sure there is no bystander within 15 m
radius and pay enough attention to objects in
the surroundings before starting operation.
• Do not rotate the cutting head at more than 10,000
r/mim.
• Do not hit the cutting head against hard foreign
matters such as rocks, concrete, tree stub
and bottle etc.
• When releasing Nylon line from spool hit tap knob
of spool against the ground surface lightly
at rotation speed lower than 4,500 r/min.
•
Cut off knife on the guard adjusts cutting swath to
40 cm automatically by cutting nylon lines evenly
when attachment starts rotating.
•
When operating with less than maximum cutting
swath (40 cm), cut two nylon lines in equal lengths.
CAUTION
Use only flexible, non-metallic line
recommended by KIORITZ CORPORATION.
REPLACING NEW NYLON LINE
(1) Press "retaining pawls" ( at two places ) inward
and remove cover.
It is easier to remove one after another.
(2) Remove spool.
(3) When Nylon line on the spool is almost exhausted
remove remaining line from spool and wind "new
line" according to the procedures (4) and beyond.
When the line on the spool is "melted and stuck"
remove the entire line while peeling off the "melted
and stuck" portion and wind the "removed line"
anew according to procedures (4) and beyond.
14