Related Manuals for treston 905998
Summary of Contents for treston 905998
- Page 1 ASSEMBLY INSTRUCTIONS Cornerstone Bench 905998 12/16/2022 1 (8) Quick assembly video Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
-
Page 2: Tools Required For Installation
• (4) upright tabs • (4) M8 x 16 bolts rear case assembly front leg assembly depth kit rails leg tubes telescoping legs Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us... - Page 3 ASSEMBLY INSTRUCTIONS Cornerstone Bench 905998 12/16/2022 3 (8) M8x20 M8,4 Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
- Page 4 ASSEMBLY INSTRUCTIONS Cornerstone Bench 905998 12/16/2022 4 (8) M8 x 20 M8 x 20 Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
- Page 5 ASSEMBLY INSTRUCTIONS Cornerstone Bench 905998 12/16/2022 5 (8) M8 x 20 M8 x 20 Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
- Page 6 DO NOT USE provided screws from the hardware pack provided with the table. These screws are for laimate work surfaces only. Treston phenolic tops can be assembled in 2 ways: • Mechanical fasteners - Screws to be provided by the installer. Pre-drill a pilot hole in the bottom of the work surface, taking care to keep from penetrating through the top.
- Page 7 (see steps 1-4). Tighten all bolts. Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
- Page 8 **Provided wood screws are for laminate work surfaces >25mm. DO NOT USE PROVIDED WOOD SCREWS FOR 3/4” PHENOLIC TOPS. Treston • 156 Bluffs Court, Canton, GA 30114 Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
Need help?
Do you have a question about the 905998 and is the answer not in the manual?
Questions and answers