Page 5
DO NOT USE provided screws from the hardware pack provided with the table. These screws are for laimate work surfaces only. Treston phenolic tops can be assembled in 2 ways: • Mechanical fasteners - Screws to be provided by the installer. Pre-drill a pilot hole in the bottom of the work surface, taking care to keep from penetrating through the top.
Page 6
(see steps 1-3). Tighten all bolts. NOTE: If adding a bottom shelf, depth kit rails should be Treston • 156 Bluffs Court, Canton, GA 30114 mounted with lip facing out to support shelf brackets. Tel. 800.437.6772 • Fax 770.720.6584 • infousa@treston.com • www.treston.us...
Page 7
For phenolic tops, please refer to laimate work surfaces only. work surface instructions, right. Treston phenolic tops can be assembled in 2 ways: • Mechanical fasteners - Screws to be provided by the installer. Pre-drill a pilot hole in the bottom of the work surface, taking care to keep from penetrating through the top.
Need help?
Do you have a question about the Cornerstone Bench 905998 and is the answer not in the manual?
Questions and answers