Cisco ME 3400 Hardware Installation Manual page 31

Chapter 2 Switch Installation
Table 2-1
SFP Module
1000BASE-SX
(GLC-SX-MM)
1000BASE-LX/LH
1000BASE-ZX
(GLC-ZX-SM
CWDM
1. A mode-field diameter/cladding diameter = 9 micrometers/125 micrometers
2. A mode-conditioning patch cord is required. Using an ordinary patch cord with MMF, 1000BASE-LX/LH SFP modules, and
a short link distance can cause transceiver saturation, resulting in an elevated bit error rate (BER). When using the LX/LH
SFP module with 62.5-micron diameter MMF, you must also install a mode-conditioning patch cord between the SFP
module and the MMF cable on both the sending and receiving ends of the link. The mode-conditioning patch cord is required
for link distances greater than 984 feet (300 m).
3. 1000BASE-ZX SFP modules can send data up to 62 miles (100 km) by using dispersion-shifted SMF or low-attenuation
SMF; the distance depends on the fiber quality, the number of splices, and the connectors.
Note When using shorter distances of single-mode fiber-optic cable, you might need to insert an inline optical
attenuator in the link to avoid overloading the receiver.
When the fiber-optic cable span is less than 15.43 miles (25 km), you should insert a 5-decibel (dB) or
10-dB inline optical attenuator between the fiber-optic cable plant and the receiving port on the
1000BASE-ZX SFP module at each end of the link.
Operating environment is within the ranges listed in
•
Clearance to front and rear panels is such that
•
–
–
–
Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent
•
lighting fixtures. Make sure that the cabling is safely away from other devices that might damage
the cables.
OL-7677-01
Fiber-Optic SFP Module Port Cabling Specifications (continued)
Wavelength
(nanometers)
850
1300
1550
1470, 1490,
1510, 1530,
1550, 1570,
1590, 1610
Front-panel indicators can be easily read.
Access to ports is sufficient for unrestricted cabling.
Rear-panel power connector is within reach of an AC power receptacle.
Core Size
Fiber Type (micron)
MMF 62.5
62.5
50
50
2
MMF 62.5
50
50
SMF 9/125
SMF 9/125
1
SMF G.652
Appendix A, "Technical Specifications."
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
Preparing for Installation
Modal
Bandwidth
(MHz/km) Cable Distance
160 722 feet (220 m)
200 902 feet (275 m)
400 1640 feet (500 m)
500 1804 feet (550 m)
500 1804 feet (550 m)
400 1804 feet (550 m)
500 1804 feet (550 m)
— 32,810 feet (10 km)
— 43.4 to 62 miles
(70 to 100 km)
— 62 miles (100 km)
3
2-5