Advertisement
INSTALLATION
• This product must be installed by a licensed electrician or qualified trade professional.
• Before installation, ensure that the power supply to the switch is turned off.
• The installation location of the light switch must have a neutral wire. Where multiple
neutral wires are present, ensure that it is the same neutral wire as the light intended to
be controlled.
• When installing, the junction box should not be greater than: 71x45x26mm.
• Confirm all the wiring is correct before turning on the main power to avoid hazards.
Wiring Diagram
Follow the wiring diagram below to connect the wiring to the light switch. Note: The
diagram is for a 3 gang switch, 1 & 2 gang models will have the respective number of lights
to wire.
Notes:
• This product must be protected by a 10A circuit breaker.
• The switched circuits cannot be used in SELV/PELV circuits.
Light 3
Light 2
Light 1
Live wire
Neutral wire
Ground wire
Advertisement
