Craftsman 247.88791 Operator's Manual page 9

4. Place chute onto chute base and ensure hex rod is positioned
under handle panel. Install hex bolt previously removed but do
not secure with wing nut at this time. See Figure 4.
5. Squeeze the trigger on the handle panel joystick and rotate the
chute by hand to face forward. The holes in the chute control
input will be facing up. See Figure 5.
NOTE: The chute will not rotate without squeezing the trigger on the
joystick.
6. Rotate the joystick to the one o'clock position so the silver
indicator arrow on the input shaft below the control panel points
upward. See Figure 6.
NOTE: The joystick will be angled slightly to the right. See Figures 5 &
6.
ASSEMBLY
Figure 4
Chute Control
Joystick
9
Top View
Input
Joystick
Figure 5
Front View
Figure 6