Installing The Batteries; Using The Remote Control; Connections; Connecting The Antenna And Lnb (Low Noise Block) To The Receiver - Strong SRT 7807TIVU User Manual

13. 1
14. 3
15. 5 6
16. 4
17. P+/P-
18. MEDIA
19. INFO
20. EPG
21. EXIT
22. TV/R
23.

2.6 Installing the batteries

Remove the battery cover from the remote control and put 2x AAA size batteries inside the
compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
NOTE:

2.7 Using the remote control

To use the remote control, point it towards the front of the digital receiver. The remote control has a
range of up to 7 metres from the receiver, if properly aligned towards the IR eye on the front panel.
The remote control will not operate if its path is blocked.
NOTE:

3.0 CONNECTIONS

This section explains the most important functions to ensure that you can directly watch television with
your new receiver. Please note additional adjustments may be required.
NOTE:
3.1 Connecting the antenna and LNB (Low Noise Block) to the
receiver
Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good quality
coaxial cable and suitable 'F-connector' plugs.
6
Play Key
Stop Key
Fast Rewind Key/Fast forward Key
\
Chanel up/down
Gives access to Media menu
Display Current/Next Event name,and Event Information
Display information about the Program Guide
Returns to the previous menu or exits the whole menu
Switch TV and radio channels
Mute/ Unmute the sound
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
Sunlight or very bright light might decrease the sensitivity of the remote
control.
Do not connect the receiver to the main power yet.
Fig. c
Fig. 7
Fig. 8