Advertisement
Please always keep the following safety precautions in mind!
Never connect the device to any other voltage than indicated in the specifications. Under no
circumstances should the device come into contact with the mains voltage of 230 V ~!
It is essential to observe the lightning protection regulations for the outdoor operation of
electrotechnical systems! The antenna must be properly equipped with lightning protection when
installed outside a protected area (e.g. house). The HF bypass must be equipped with overvoltage
protection. In case of lightning hazard, immediately take the antenna out of operation and
disconnect it safely from other devices (remove HF connection)!
Observe the permitted temperature range for starting up the device! Do not switch the device on or
off again if this range is exceeded or fallen below!
When disassembled, always provide a safe placement on a flat, straight and solid base of
sufficient carrying capacity! The antenna is intended for outdoor installation on firmly anchored
components (mast, beams, roof, wall, ...). Observe the permissible wind load! Always transport the
device either in solid cardboard or wooden boxes (e.g. the delivery packaging), or transport it by
firmly gripping the amplifier housing! The device may cause injury in the event of a fall due to its
own weight!
Never expose the device to mechanical stress due to impact, pressure, vibration or shock which
exceed a normal level. Never carry or attach the antenna to the antenna elements.
Never open housings and never move screw connections on the housings, unless expressly
requested in the operator manual. This can lead to damage to seals or components connected to
the screw connections.
If you notice any damage to the device, immediately take it out of operation (remove power
supply)! If necessary, send it to the supplier for repairs.
Would you like to dispose the device due to damage or no more usability, send it back to the
supplier or return it to your local waste collection center. Never dispose of the appliance
elsewhere, such as household waste. It pollutes our environment!
The nameplate of the RLA4G is located inside the amplifier housing. It is visible after removing the
base plate.
VERSION
DATE
1.4
24.11.2021
Safety precautions
K & M Burkhard Reuter
NAME
RLA4G/GS
B. Reuter
3
8
Page
of
Advertisement
