Connecting Vhf And Uhf Antennas - Samsung TP29J10 Owner's Instructions Manual

2
C h a p t e r Tw o
14
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads," below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads," on page 15.
If you have two antennas, see "Separate
VHF and UHF Antennas," on page 15.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the
screws on the 300-75
ohm adaptor (not sup-
plied). Use a screwdriver
to tighten the screws.
2
Plug the adaptor into
the VHF/UHF terminal
on the bottom of the
back panel.
Antennas with 75-ohm Round Leads
1
Plug the antenna lead
into the VHF/UHF
terminal on the bottom
of the back panel.