Table of Contents
Advertisement
O
P E R AT I O N
Adjust Red Convergence
4
While "Red" is highlighted (letters are
blue color), press the VOL+ button:
A crosshair pattern will appear on the
screen. If either a vertical or a
horizontal red line is visible, then the
convergence needs alignment.
5
If a horizontal red line is
visible, use CHL and CHM buttons
to move the line so that it is super-
imposed on the horizontal center-
line (i.e., make a single horizontal
line that is as white as possible.)
6
If a vertical red line is visible, use
the VOL + and VOL - buttons to
move the line so that it is superim-
posed on vertical-center line (i.e.,
make a single vertical line that is as
white as possible.)
7
At this point, the Red convergence
is correctly adjusted. Press MENU,
then press the CHM button once to
highlight the word "Blue."
Adjust Blue Convergence
8
While the word "Blue" is highlight-
ed, press the VOL+ button to adjust
the blue convergence. When the
crosshair pattern appears, use
CHL and CHM and VOL
converge the blue line (same
procedure as in steps 1~7, above).
9
After the blue convergence is
correctly adjusted, press MENU four times to exit all the menus.
+ -
to
C
T
: TV O
HAPTER
HREE
PERATION
3.2
Advertisement
Table of Contents
